QD Cover Installation

You will need:

1. Vise that opens to at least 4½”

2. Female QD

3. Male QD

4. Cool Connect™ QD Cover

5. ⅞” Socket

If you heat up the cover in boiling water or water heated up in a microwave, it will make it a little easier to go on

Connect the male and female QD

Take the female QD and place it in the large end of the Cool Connect™ cover, (remember it is hot) and then place between jaws of the vise, and tighten until it stops

Next open the jaws to allow the ⅞” socket to go between the Cool Connect™ cover and the jaws. Center it and close the jaws some more until the female QD comes to a stop.

Remove from the vice and viola! You’re done.

It’s that easy